Lib cruise control details wanted

Fury · Post by **Fury** » Sun May 21, 2006 3:31 pm

Does anyone have a wiring diagram or knowledge of how a Liberty cruise control works?

I have the main componants, but would like to confirm all the parts.

I also don't seem to have a speed sensor

..which I obviously need - or does it hook up to the back of the speedo.

componants I have:

control unit module
steering column stalk
dash mount - on / off switch,
pedal de-activation switches
throttle actuator with vacuum pump
and wiring loom - which I still have to strip

This is a from scratch installation, so need all the help I can get.

I was going to install an aftermarket one ( which I do have ) but would prefer to do this one if I can.
Cheers
Chris

Chris_Rogers · Post by **Chris_Rogers** » Sun May 21, 2006 5:49 pm

spped comes off teh back of the speedo. (its a reed switch.)

if its like the generic items then:
speed pulse to unit
brake supply input
brake lamp input
clucth input (maunal)
VAC input
IGN and gnd.

and it goes.

(give me a ring too.)

Fury · Post by **Fury** » Sun May 21, 2006 5:56 pm

Thanks Chris,
Pretty much what I thought, just got to match the correct wires together -

As there was no sender, I thought that could be the case - just not sure which wire...

I'll pm you later. Qld at the end of the week...

I cant seem to find anything about the original specs or schematics, the downloaded FSM doesn't seem to have anything about it...

Chris_Rogers · Post by **Chris_Rogers** » Sun May 21, 2006 6:02 pm

cool. (bring it with you if you can.)

PeeJay · Post by **PeeJay** » Sun May 21, 2006 7:15 pm

Wiring diagram here:
http://www.driftquebec.com/legacy/

Fury · Post by **Fury** » Sun Jun 11, 2006 9:01 am

PeeJay wrote:Wiring diagram here:
http://www.driftquebec.com/legacy/

Mate...I forgot to say thanks

This will certainly help
( was too busy checking it out to reply and only when finding it again, reealised I hadn't posted a thank you.... 1 very important item - especially If you want continued help

)

Still interstate and havn't got it installed yet...
cheers
Chris

wagonist · Post by **wagonist** » Wed Jun 28, 2006 6:22 pm

Are you installing it into a Lib, or something else?
I'm adding Lib cruise to my L.

A couple of things to watch out for:
The cruise switches for the brake & clutch are normally closed switches (ie break circuit when switch is pressed), whereas the brake switch is normally open.
I'd recommend using the Lib switches & fit them (the Lib brake switch has 4 wires coming off it)

For the speed sensor on the back of the L cluster, its the screw between the speedo cable & the cente part thats NOT labelled 100k. Trace that with a multimeter back to the multi-pin plug (the other one is for the 100km.h chime on JDM cars)

Fury · Post by **Fury** » Thu Jun 29, 2006 11:22 am

Thanks for the heads up, Installing into the Vortex, just getting a few more bits together.
So much to do....

Now, which project was I doing first?