Brumby rear torsion bar swap.

SuBaRiNo · Post by **SuBaRiNo** » Thu Jan 03, 2008 8:35 pm

If i had a spare brumby... would swaping the rear torsion bar into my hatch be worth while? (the hatch currently runs a Wagon torsion bar)

I heard a rumour that brumby rear torsion bars were beafed up to handle access wait in the tray.

Also is there any visable difference??

Dave

90brumby · Post by **90brumby** » Thu Jan 03, 2008 8:46 pm

ive got 1 sittin at my place if u wanna have a look at it n if u want it please take it b4 it gets thrown out

SuBaRiNo · Post by **SuBaRiNo** » Thu Jan 03, 2008 8:52 pm

i got an entire spare brumby... so no i don't want it... just want to know if there is any physical difference.

If there is im sure Mattack will snatch yours up if it's a benfit.

Dave

TW83 · Post by **TW83** » Tue Jul 08, 2008 10:30 pm

Did you manage to find out if there is a difference?

SuBaRiNo · Post by **SuBaRiNo** » Wed Jul 09, 2008 7:51 pm

No idea... i have a brumby one on hand but they physically look the same.

Dave

daza · Post by **daza** » Thu Jul 10, 2008 7:46 am

SuBaRiNo wrote:No idea... i have a brumby one on hand but they physically look the same.

Dave

Your the only one with a Hatch Dave...
But i put a complete wagon assembly in my Brumby with no issues after a broke both torsion bars.
Felt a little softer, can't comment on ride height, i wound it up straight away.
I wouldn't think it would make enough difference to bother unless it needed to come out already.
Daza.

brumbyrunner · Post by **brumbyrunner** » Thu Jul 10, 2008 1:43 pm

I don't know about wagon torsion bars but the coupe ones are lighter than Brumby ones.

BRUMBI · Post by **BRUMBI** » Thu Jul 10, 2008 4:33 pm

ive read on usmb that the utes had thicker ones

Post by **Captain Obvious** » Thu Jul 10, 2008 7:57 pm

yes brumby are thicker and are supposed to be better.....

daza · Post by **daza** » Thu Jul 10, 2008 8:17 pm

There definatly was a difference, just not that much...
Daza.