Rear wheel bearing 4wd l series help needed

suby87 · Post by **suby87** » Mon Oct 09, 2006 1:25 pm

Hey Guys,

Just got the bearing back from the shop all pressed into the housing and all. The guy said something about having to tighten the rear nut up after it is all back in the car to get the right tension so as not to overtighten it. Is this right as this would be very difficult? any advise about getting this thing back in would help

thanks

SuBaRiNo · Post by **SuBaRiNo** » Mon Oct 09, 2006 1:43 pm

Im confused??? Which nut??? the outside one of the inner ring nut thing??

Rear wheel bearings are the one thing i will gladely pay someone else to do next time... give me another ej conversion anyday.

Dave

stinky · Post by **stinky** » Mon Oct 09, 2006 4:32 pm

yeah, last time I had to do rear wheel bearings I replaced the whole lot from another car ... was heaps easier

suby87 · Post by **suby87** » Mon Oct 09, 2006 6:49 pm

dave it is the inner one. He said be careful not to over tighten it is that right?