Bantum's '82 Touring Wagon ...

[Bantum]

Latest bit work done ;

Finished putting together the roof rails :



Note : 3d print is availble on Thingiverse ... Link : https://www.thingiverse.com/thing:1478397



& Installed them :



Next on the cards is the graphics ... ( will have to move it first so I can get access all round )

Cheers, Bantum ...

[El_Freddo]

Looking good Bantum! Will you ever throw some luggage up there or too worried about damaging the paint?

And I see you’re operating out of a shipping container, that would be tight (but better than nothing)!

[Bantum]

Will eventually put something on it - not sure what yet as it will have to be light weight & not too bulky ...

Yep its a bit tight in the continer, a move is on the cards ... Engine has to come out & things fixed to be ready for SubiNats ...

Ciao, Bantum ...

[Bantum]

Bit more progress on the wagon - Finally got round in moving it to a suitable 'garage' to work on it ...



Did a bit of cleaning up & removed the Engine ...





Next will be some tidying up & installing the engine swap ( from Brumby )

Cheers, Bantum ...

[El_Freddo]

Bantum, I didn’t realise your touring wagon was auto - maybe I missed that detail earlier.

I like the spray can cap on the carby, or is this a 3D printed number?

And what’s with the pipework on the PS rack? It seems to go everywhere and looks painful if you ever needed to pull the rack out!

[Bantum]

No, its the old the paint can lid trick ...

Yer the pipe work to power steering is a bit of a spagetity nightmare, hoping for now that it doesn't leak to much ... :/

I'm in a bit of a quandry though - The motor I took out of the wagon had power steering, the one I'm replacing it with from the Brumby dosen't - Problem is the vaccum line takeoff on intake to master brake is in a slightly different location, not allowing the power steering pump to fit - so am looking to relocate the off take ...

Brumby Engine :



Comming in hot :



So anyone got a solution suggestion / recommendations ?

Ciao, Bantum ...