Frog away

YouTube · Post by **El_Freddo** » Mon Feb 06, 2012 11:38 am

FROG wrote:if you were waiting on me and I havnt replied by this afternoon , please recontact me as Ive probably lost the information
cheers all

I'll be sending an order in soon - just have to remember what I needed

Cheers

Bennie

FROG · Post by **FROG** » Mon Feb 06, 2012 8:39 pm

El_Freddo wrote:I'll be sending an order in soon - just have to remember what I needed

Cheers

Bennie

found an old quote I did for you last year today - March I think it was - gearbox bits

YouTube · Post by **El_Freddo** » Tue Feb 07, 2012 9:37 pm

FROG wrote: found an old quote I did for you last year today - March I think it was - gearbox bits

Nah, that's not the one, I think I'm just going to use the bearings that are still in there, everything moves without issue and I've had a good experiences with re-using gearbox bearings so I'll run that gauntlet...

What I need is:

1x EA81 oil pump re-seal kit + the pressure valve spring

1x crankcase ventilation hose for an EJ - the stumpy bugger that sits below the T we replaced last september (not that I expect you to remember everyone's orders for the last couple of years!), it's the one that sits directly on the crackcase near the temp sensor area - I hope this makes sense

6x (I think) plastic clips for the chrome strip on the brumby's tailgate

I'm pretty sure that's it...

Cheers

Bennie

FROG · Post by **FROG** » Tue Feb 07, 2012 9:55 pm

El_Freddo wrote:Nah, that's not the one, I think I'm just going to use the bearings that are still in there, everything moves without issue and I've had a good experiences with re-using gearbox bearings so I'll run that gauntlet...

What I need is:

1x EA81 oil pump re-seal kit + the pressure valve spring

1x crankcase ventilation hose for an EJ - the stumpy bugger that sits below the T we replaced last september (not that I expect you to remember everyone's orders for the last couple of years!), it's the one that sits directly on the crackcase near the temp sensor area - I hope this makes sense

6x (I think) plastic clips for the chrome strip on the brumby's tailgate

I'm pretty sure that's it...

Cheers

Bennie

No worries Bennie Ive already ordered that spring cause it was ex Japan so I just ordered one on my account so its here in time
I remember the hose

gone again already??

YouTube · Post by **El_Freddo** » Tue Feb 07, 2012 10:13 pm

FROG wrote:I remember the hose
gone again already??

Nah, last time it was the T piece that I broke and then replaced. What I didn't know was that I also cracked the brittle inch/inch and a half pipe below that T piece - then I lost a lot of oil after that and sand stuck to it all when we were in Robe... Fun fun.

Cheers

Bennie