Hi guys,
I know this has been asked before on how to make an extension for the 2" lift steering however I have tried again and again with no success. I found out the extra knuckle I was using was for the power steering mod. I don't want to bodge something up so my big question does anyone have one made up that they would be willing to sell or trade?
Cheers again
Steering extension link has anyone got one (sorry for the double up)
- Backyard_Brumby
- Junior Member
- Posts: 259
- Joined: Wed Dec 01, 2010 10:47 am
- Location: Brisbane
- Contact:
Steering extension link has anyone got one (sorry for the double up)
[SIGPIC][/SIGPIC]James 

- TOONGA
- Elder Member
- Posts: 5339
- Joined: Sat May 30, 2009 10:15 am
- Location: Mandurah where they divided by zero
- Contact:
A photo essay


with the above linkage setup use the two longer bits for a power steering set up(with or without the rubber vibration stopper) and remember to bolt it all together nice and tight. (no need for the extension block)
for a non power steering setup use the short end and the long end with the rubber vibration stopper, or use the standard liberty or l series knuckle shown in the picture below (top knuckle) the bottom knuckle is from an outback

images stolen from these threads
showthread.php?t=18281&highlight=steering+extension
showthread.php?t=19731
GOOD LUCK
TOONGA


with the above linkage setup use the two longer bits for a power steering set up(with or without the rubber vibration stopper) and remember to bolt it all together nice and tight. (no need for the extension block)
for a non power steering setup use the short end and the long end with the rubber vibration stopper, or use the standard liberty or l series knuckle shown in the picture below (top knuckle) the bottom knuckle is from an outback

images stolen from these threads
showthread.php?t=18281&highlight=steering+extension
showthread.php?t=19731
GOOD LUCK
TOONGA
- Backyard_Brumby
- Junior Member
- Posts: 259
- Joined: Wed Dec 01, 2010 10:47 am
- Location: Brisbane
- Contact: