WRX seats in an L Series

apg39 · Post by **apg39** » Sun May 15, 2011 3:00 pm

Done a quick search but couldn't find info...only people saying it can be done with mods.

What sort of modifying needs to be done? I imagine the rails but what?

I have a set from my old car & contemplating installing them...or turn them into office chairs.

Gannon · Post by **Gannon** » Sun May 15, 2011 5:49 pm

They will be exactly the same as installing Liberty or Impreza seats. A search for these should give you a better start

guyph_01 · Post by **guyph_01** » Sun May 15, 2011 8:02 pm

Have a look at Dann's build thread:)
He has covered it and done it properly.

Post by **Alex** » Mon May 16, 2011 9:55 am

the rear mounting holes need to be re-drilled and thats about it.

I ran wrx seats in my l-series.

guyph_01 · Post by **guyph_01** » Mon May 16, 2011 11:45 am

I think the amount of mods also differ with the year the seat were from. I have some gc8 sti seats and they just needed holes drilled like alex to allow the L rails to bolt on. but i also have Bug eye and they will need totally different mods similar to what Dann has done. My bro has some 05RX bucket seats in his RS altho they bolt in the RS would nee different mods as the rails are a different design.

I think the basic way to mod them is the same, you just have to have everything in front of you, some brains and some mod skills:)
Dann thread is a good start:p
Page 4
showthread.php?t=19305&page=4

theconcierge · Post by **theconcierge** » Fri May 27, 2011 7:36 pm

has anyone actually got a photo of a brumby with WRX seats? I know it's been done, but as yet, I haven't seen a photo

guyph_01 · Post by **guyph_01** » Fri May 27, 2011 9:46 pm

This is more for apg39.
My l series with sti seats. Steering wheel is low because its not bolted up in the car yet.

I'll take pics of the mods i did a post it tomorrow.