Brumby seat question

[phantomD]

Hi all,

My Brumby seat is poking me in the back and causing me back pain - how much would it cost to get both seats refurbished in Brisbane? Any places recommended?

Can somebody please tell me which model/year Liberty the seats below came from:



Are modifications required to fit them to a Brumby?

Cheers,
D

[Captain Obvious]

they are the same as my seats, gen 1 ser 1 liberty!!

[RSR 555]

Yep.. Gen 1 Series 1 GX Liberty seats.. I prefer the RS Turbo seats in there, as they have the slightly rap around sides

[phantomD]

Much modding required to put them in?

[1111giles]

Check out Foz seat too they fit well (with mods to the fixings) get the correct colour and they look factory ! Dinky arm rests are good too

See image of my set up

[TOONGA]

D this will help you out on the "can I fit these in my brumby" question

1998 Gen2 seats into 1984 MY wagon

not gen1 series 1 but I hope this helps

TOONGA

[tex]

the rails (the bits that bolt between the seats and the floor! will normally be the bits that have been modified so another set of liberty seats should bolt up if you remove the seats and bolt the old rails onto the new seats!