Vacuum hoses (EA81 Weber Upgrade)

Wombat · Post by **Wombat** » Sat May 15, 2010 6:38 am

After swapping carb i am left with vac lines that seem to be going everywhere and yet not doing what they were meant to. (Anti Backfire - Charcoal Cannister and so on). Am i right in assuming that since all these were connected to the original carb that they are now redundant and i can remove everything back to the inlet manifold and then seal off. All comments appreciated.
All The Best Dave

2coupedup · Post by **2coupedup** » Sat May 15, 2010 9:08 am

some people do... but i modified the original airfilter housing to take the webber, so most hoses are still in use...

preno · Post by **preno** » Mon May 17, 2010 9:44 pm

i took most things of but i have left the Charcoal Cannister there an have hooked it up to the weber.

the link below shows what hose goes where

http://www.subarubrat.com/Retrofitting% ... V%2032.htm

cheers

matt

Post by **TOONGA** » Mon May 17, 2010 9:53 pm

http://www.subarubrat.com/Retrofitting% ... V%2032.htm

this will be good to know when I get my engine in to my brumby

thanks

TOONGA

Wombat · Post by **Wombat** » Tue May 18, 2010 5:48 am

Thanks everyone. That's all i need to know.