torque setting for knock sensor ?

steptoe · Post by **steptoe** » Tue Feb 10, 2009 8:22 pm

According to WSM the knock sensor s to be tightened to specs

I cannot find

Anyone know ?

EA82

ta,

Suby Wan Kenobi · Post by **Suby Wan Kenobi** » Tue Feb 10, 2009 9:06 pm

25-35Nm but as they are tapered i have usually done them up so they are just tight, which would be in the ball park of the torque spec anyway

steptoe · Post by **steptoe** » Wed Feb 11, 2009 8:57 am

Thanks Suby Wan Kenobi. I will shove that in the manuals somewhere I CAN find it.

BTW, did you get this figure from the manuals, if so where ??

Jonno

Suby Wan Kenobi · Post by **Suby Wan Kenobi** » Thu Feb 12, 2009 5:32 pm

From the FSM

stinky · Post by **stinky** » Thu Feb 12, 2009 6:10 pm

I think it's 18 lb/ft in imperial.

steptoe · Post by **steptoe** » Fri Feb 13, 2009 8:28 am

Thanks guys , converts to 18 - 25 ft lbs

tex · Post by **tex** » Sat Feb 14, 2009 10:34 am

How much did your Knock sensor cost you my poor wagon needs one.

vincentvega · Post by **vincentvega** » Sat Feb 14, 2009 10:37 am

EJ22 = $140ish

steptoe · Post by **steptoe** » Sun Feb 15, 2009 9:03 am

tex, wasn't fitting newie, just swapping between motors