Fitting a L series bullbar to a Brumby

Green_eyed_liberty · Post by **Green_eyed_liberty** » Sat Jul 03, 2010 12:27 pm

will a Bullbar for an L Series fit a brumby?

i've been told they dont fit, how far dont they fit?

could it be easy modified to fit? or will i need to sell it lol

cheers guys

Subafury · Post by **Subafury** » Sat Jul 03, 2010 12:40 pm

no. bugger it off it wont fit.different width chassis rails.

YouTube · Post by **El_Freddo** » Sat Jul 03, 2010 10:59 pm

^ what subafury said + the L series bullbar has the captive nuts on it where as the MY or brumby's "chassis rail" will have the captive nuts in it. The bullbars are a physically different in width as well, not by much but enough not to look the part...

Cheers

Bennie

stamp_licker · Post by **stamp_licker** » Sun Jul 04, 2010 5:53 pm

I've made one that was fitted on a brumby fit my L .It's just a couple of bolt on brackets easy to fab. A reversal shouldn't be hard , L to brumby should be doable .

Wagonman · Post by **Wagonman** » Sun Jul 04, 2010 8:49 pm

I fitted a brumby bullbar to my L. Had to modify (hack the crap out of) it because it was too narrow so i would think an L series one IF you could get it to fit would look very out of place. good luck if you try though mate

red_rocket · Post by **red_rocket** » Sun Jul 04, 2010 10:55 pm

ill take the L bullbar if you dont use it...shipping will kill though