FS: MY slanted console to suit DIN stereo
FS: MY slanted console to suit DIN stereo
Item............................... Used but complete (brackets, ashtray, all mounting screws) MY series (including second gen Brumby) slanted stereo console.
Description...................... Rare as the proverbial, I have seen maybe 1/2 a dozen of these in the past several years. Only found in base model MY's, these have the capacity to (a) fit a standard DIN stereo, and (b) are slanted so you can insent/eject a CD while in 1st/3rd/5th, which can't be done with a standard console. Colour is tan, which can be easily painted using interior spray paint to match the more common grey (the grey slanted console's are almost impossible to find as very few MY's from 1981-84 had gray interiors).
Condition........................... Very good - general wear but no cigarette burns, deep scratches, or holes drilled as they are often found.
Location ..........................Melbourne, but will post anywhere in the world.
Price................................$25 + shipping (at cost).
Contact ............................ Reply post ONLY...no PM's please. First in best dressed!
Description...................... Rare as the proverbial, I have seen maybe 1/2 a dozen of these in the past several years. Only found in base model MY's, these have the capacity to (a) fit a standard DIN stereo, and (b) are slanted so you can insent/eject a CD while in 1st/3rd/5th, which can't be done with a standard console. Colour is tan, which can be easily painted using interior spray paint to match the more common grey (the grey slanted console's are almost impossible to find as very few MY's from 1981-84 had gray interiors).
Condition........................... Very good - general wear but no cigarette burns, deep scratches, or holes drilled as they are often found.
Location ..........................Melbourne, but will post anywhere in the world.
Price................................$25 + shipping (at cost).
Contact ............................ Reply post ONLY...no PM's please. First in best dressed!
1989 Brumby - Shiny new red paint, stroked EJ20 phase 2 SOHC with Darton sleeves bored to EJ22, Wiseco high-compression pistons, Delta 2000 grind cams , EJ/XT6 5 stud with WRX 4/2 pots, 5-speed, 86 GTS seats and so much more.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
- Brumby Kid
- General Member
- Posts: 1297
- Joined: Sun Jul 17, 2011 9:19 pm
- Location: Belair S.A.
Not that I can have it but would you mind taking a picture of what this is?
It seems pretty rare from what you were saying. I think I know what it looks like.
Cheers Cam
It seems pretty rare from what you were saying. I think I know what it looks like.
Cheers Cam
When life gives you a corner, drop a gear, pitch, and stomp the loud pedal
Bianca: 1991 Subaru Brumby
My First / Project car
EA81 Rebuilt by Tony Knight from knight Engines
2" body lift
25" 185r14 Yokahama Delivery Star, light truck tyres
2" Sports exhaust
Rear Aguip step/bar
Liberty seats
Mums Car 08 Liberty Wagon
Bianca: 1991 Subaru Brumby
My First / Project car
EA81 Rebuilt by Tony Knight from knight Engines
2" body lift
25" 185r14 Yokahama Delivery Star, light truck tyres
2" Sports exhaust
Rear Aguip step/bar
Liberty seats
"Bianca"
[SIGPIC][/SIGPIC]
Dads Car: 02 Impreza WRX STi[SIGPIC][/SIGPIC]
Mums Car 08 Liberty Wagon
- Silverbullet
- Senior Member
- Posts: 2921
- Joined: Mon Aug 23, 2010 6:20 pm
- Location: Adelaide
Is there only 1 kind of slanted console? Cos my old wagon has a slanty slot where the old tape deck sits...didn't know they were rare. Mine has been sufficiently butchered though (not by me)
Will it ever end!?
-EA81 TWIN CARB!!!!
-L series 5 speed
-Custom paint job
-2" lift
-Full custom re-wire
-L series front end

-EA81 TWIN CARB!!!!
-L series 5 speed
-Custom paint job
-2" lift
-Full custom re-wire
-L series front end

- RSR 555
- Elder Member
- Posts: 6951
- Joined: Sat Nov 10, 2007 10:42 am
- Location: ATM... stuck in Rockingham
Certainly I'd admit they are becoming harder to find but calling them 'rare' might be pushing it a bit, they are still around.
Although, having one not cut up to fit single DIN stereo.. that would be rare
For $25 + postage = bargain
Although, having one not cut up to fit single DIN stereo.. that would be rare
For $25 + postage = bargain
You know you are getting old when the candles on your birthday cake start to cost more than the cake itself.
RSR Performance
Home of the 'MURTAYA' in Oz
Subaru Impreza WRX based Sportscar
[SIGPIC][/SIGPIC]
Disclaimer: Not my website but hyperlink here to Subaru workshop manuals
RSR Performance
Home of the 'MURTAYA' in Oz
Subaru Impreza WRX based Sportscar
[SIGPIC][/SIGPIC]
Disclaimer: Not my website but hyperlink here to Subaru workshop manuals
Pic as requested.

555ron, you have a PM.

555ron, you have a PM.
1989 Brumby - Shiny new red paint, stroked EJ20 phase 2 SOHC with Darton sleeves bored to EJ22, Wiseco high-compression pistons, Delta 2000 grind cams , EJ/XT6 5 stud with WRX 4/2 pots, 5-speed, 86 GTS seats and so much more.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
Silverbullet, you could well have a slanted console as factory. The easiest way to differentiate (apart from the deck angle) is the Brumby's have a pull-out cigarette tray and the slanted console has a flip-up door for the tray. I've never seen a Brumby with a slanted console ex-factory.
I am starting to think the slanted console might have been for an optional (maybe FM capable?) radio...I have previously only found them on early MY's (1981, 82) but the one posted came from a late run (84). So my thoughts on them being fitted to base models might be backwards...
I am starting to think the slanted console might have been for an optional (maybe FM capable?) radio...I have previously only found them on early MY's (1981, 82) but the one posted came from a late run (84). So my thoughts on them being fitted to base models might be backwards...
1989 Brumby - Shiny new red paint, stroked EJ20 phase 2 SOHC with Darton sleeves bored to EJ22, Wiseco high-compression pistons, Delta 2000 grind cams , EJ/XT6 5 stud with WRX 4/2 pots, 5-speed, 86 GTS seats and so much more.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
Contact me for reproduction XT6 hubs...and EA82 rear discs.
- Silverbullet
- Senior Member
- Posts: 2921
- Joined: Mon Aug 23, 2010 6:20 pm
- Location: Adelaide
Yep that's the one, exactly the same as mine. I used the ash tray to keep my coins in, and the broken fuel filler door key
And the earliest radio I remember we had in there was an FM radio with cassette player, fitted a few years after car purchase with 2 speaker stereo. I won't be using mine though when my car is finished, I like the brumby console better since it will better fit what I want to do with it 


Will it ever end!?
-EA81 TWIN CARB!!!!
-L series 5 speed
-Custom paint job
-2" lift
-Full custom re-wire
-L series front end

-EA81 TWIN CARB!!!!
-L series 5 speed
-Custom paint job
-2" lift
-Full custom re-wire
-L series front end
