MY clock makes way for....

steptoe · Post by **steptoe** » Sun Sep 30, 2007 2:49 am

a 2" electric oil pressure gauge. Fiddling with a nagging idea this arvo, I removed the clock from a spare gauge unit, drilled a coupla holes thru circuit board where it didn't matter and bingo, an oil presure gauge will soon be sitting neatly where the clock was in my Brumby

Subafury · Post by **Subafury** » Sun Sep 30, 2007 3:39 pm

noice. on the subject, what should an L series oil pressure be reading? at cruising, start up, underload etc, mine sems to vary all over the place.

steptoe · Post by **steptoe** » Mon Oct 01, 2007 9:13 pm

about the middle of the dial as far as I reckon.

This is gonna work out nicely as I can power and ground the gauge off the back of the circuit board and use a spare pin to fit a lead into the connector at the back - reducing the wiring to a minimum