Boost gauge and Tee on the way .

[discopotato03]

I ordered a few more things from Turbosmart , their 52mm compound boost gauge TS-0101-2023 and their black boost "Tee" TS-0101-1002 .

I like the gauge because it reads above and below atmospheric pressure and is not mega expensive or gaudy like say an Autometer one would be , this will be used to set roughly std boost pressure to start with and until I find out how to bypass the fuel cut solenoid . http://www.turbosmartonline.com/index.php?id=41


The boost tee is good in that it uses a spring loaded ball valve and its inlet barb has a small hole through it to provide the restriction so that the bleed itself doesn't need to be very big .
I think these are a pretty basic thing and while not as good as a pressure sensing solenoid valve system not nearly as expensive either . http://www.turbosmartonline.com/index.php?id=43

For what I want these bits should be adequate .

Cheers A .