Page 1 of 1
crossmember mounts
Posted: Wed Sep 28, 2011 6:32 pm
by made24x4
I herd the angle on the crossmember mounts is slightly out when dropping an ej20 into an l series does anyone know anything about how to make the wedges you need to put between the crossmember and engine.
Cheers Rowan
Posted: Wed Sep 28, 2011 6:34 pm
by FROG
Posted: Wed Sep 28, 2011 6:35 pm
by Brumby Kid
made24x4 wrote:does anyone know anything about how to make the wedges you need to put between the crossmember and engine.
No need!
Just use brute force and ignorance! Along with a massive hammer! Bahahaha
Im sure some would, dont overlly sugest it though.
Cheers Cam
Posted: Fri Sep 30, 2011 9:12 am
by made24x4
cheers guys but can someone tell me the wedge ratio like is it 1in10 or whats the go
Cheers Rowan
Posted: Fri Sep 30, 2011 10:59 am
by guyph_01
Just buy them from RSR555 He sells them quite cheap:) Will save you time and troubles.
showthread.php?t=19020
Posted: Fri Sep 30, 2011 11:18 am
by Alex
or as i did, just file out the mount slots abit longer.
had no issues doing this.
(but i was running STi group N engine mounts which are stiff and strong as fjck)
if i was doing it again id definately use wedges tho. Paul RSR's seem to be the goer.
alex