Page 1 of 1
Brumby Dimensions?
Posted: Wed Jul 23, 2008 1:08 pm
by tex
I am going to soundproof my brumby and just wondering if anyone could tell me the internal size of the cab as I am away for a little while and want to order the stuff I have been told I need 1.5 times the surface area and 3 times for the doors to do them the way I want to but I can use the left overs anyway!
Thanks in advance!
Posted: Thu Jul 24, 2008 6:12 pm
by El_Freddo
It shouldn't be too hard to measure it up. If I had of read this post 3 weeks ago I could've measured a lot of the under dash areas and floor pan for you - I had the seats and dash out for a little clean up and swap of the dashboards for the sports dash...
Good luck with it
Bennie
Posted: Mon Jul 28, 2008 5:11 am
by tex
sorry maybe I should have been a little more clear on this currently I am in Canada and my car is back in australia so is a little hard to measure at the moment plus I was going to buy the materials here and ship them over.
HELP
Posted: Mon Jul 28, 2008 2:52 pm
by Alex
use dynamat...it works at a 1:5 ratio, so a piece 10x10cm will deaden an area 50x50cm. If ya get what i mean. Sure its expensive, but its GOOD. Dont bow down to the crap cheap tar-tape it peals off after afew months.
alex
Posted: Tue Jul 29, 2008 1:50 pm
by tex
Yeah I was going to go with dynamat untill I found this "
http://www.sounddeadenershowdown.com/" and although was still thinking about Dynamat decided it gets bloody hot in aus plus the people here that have tried it prefer it!