The AUSubaru.com.au Forums

I have an L series wagon, just put the crossbred kit in it along with wrx front struts and springs. The rear has standard shocks and springs, the front is lower than the back by a fair margin. Can I just put the 2" spacers from a lift kit under the towers to even out the stance or do i have to put the whole front end lift kit in there as well? I'll have a pic up this arvo to show you what is happening. Cheers:D

Just the strut top spacers will be fine.
You may need special ones to set the camber where you want it?
But the wrx hub does have adjustable camber so you should be ok as long as you are within the limits.

Picture up in 1st post!!:D

1. that car is uber friggin awesomely sexy.

2. yes you can chuck the spacers in, but it will increase your cv angle causing premature destruction.

Thanks for the compliments!:-D
So would be better of with the whole front lift kit in and maybe leave out the rear?
I have some lowered rear springs, might just throw them in again for now, looks super sexy down low all the way round!:mrgreen:

If it's a road car I'd be tackling the problem by lowering the rear.

dump it dump it dump it dump it!

if you want to lift the front a 2" lift looks like it would be too much. The lift from some forester or outback struts would be about right.

awesome looking car BTW...

Yeah Deano.. Low is the go Put those rears in and post up another pics. I have some spare rears if you want to have some as standards and some as lows? then it's just an easy swap out.. can do the same for the fronts with some Forry struts too (just f**ks up your alignment but mark the adjusting bolts with paint and you'll be close enough) for when you take off the black top

Alright, alright! I'll lower it !!!!!
Try and have it done tommorrow

would someone be able to tell me how to contact crossbred there website has no details. Something like email would be handy cheers.

If you leave a message on the contact area on the website, Jeff will get back to you pretty quick.

[email protected] wrote:would someone be able to tell me how to contact crossbred there website has no details. Something like email would be handy cheers.

Try going to the Contact section. It has a window right in the middle for you to contact him via email, and Facebook details, and his mobile number.

http://www.crossbredperformance.com/

Is that the link because i still cant find a contact form and feel like a retard. Any chance you could send me the direct link cause either my computer has shat itself or im blind. Cheers

all good mate thanks for your help... computer was up the shit

rerty wrote:Alright, alright! I'll lower it !!!!!
Try and have it done tommorrow

hehehe.. I knew you'd get the message more pics are a must when done.

Far out that thing looks SWEET.

It is pretty ballsy looking isn't it? Imagine if a wheel maker like Rod Jane made a few WRX look in 4 stud 15 and sixteens !!

Will be lowered tommorrow, had to do some husbandly things today!
I'll post it up in another section and list whats been done to it.
Thanks for all the comments and encouragement,
Cheers,
Deano

Have fitted the lower springs to the back end, didn't lower it as much as i was hoping:( anyway pretty happy with it for now!
I have put a pic up in the members cars forum,
Cheers,
Deano