MY/Brumby front guard info

Cliff R · Post by **Cliff R** » Sun Feb 28, 2016 8:56 pm

Can I please get some direction on the following.
In regards to MY/Brumby front guards were there any differences between any of the models, eg, Brumby, MY Coupe/Wagon/Sedan etc.
I am starting to look around for a front LH guard for the 82 MY Touring Wagon to replace the existing guard which has rust issues.

The ideal would be to pick up a silver guard (Paint code 15 from memory I think) but any guard at this point. I just need to know if I need to be aware of any differences between the cars.

Post by **TOONGA** » Sun Feb 28, 2016 9:19 pm

they are all the same they will all fit.

TOONGA

Cliff R · Post by **Cliff R** » Sun Feb 28, 2016 9:23 pm

Awesome, thanks for that.

Silverbullet · Post by **Silverbullet** » Sun Feb 28, 2016 9:25 pm

The only difference would be between the very first produced and the very last, as the dies and tooling got more and more worn

Cliff R · Post by **Cliff R** » Sun Feb 28, 2016 9:26 pm

Very good

Post by **Bantum** » Mon Feb 29, 2016 1:15 am

No differences in Oz, but Make sure its from Oz - as there are slight differences / variations in hole locations for US & JDM models ( like lights / mirrors etc. ) They'll still fit but you might run into trouble with them.

Ciao, Bantum ...

Cliff R · Post by **Cliff R** » Mon Feb 29, 2016 3:12 pm

Best I start looking.

YouTube · Post by **El_Freddo** » Mon Feb 29, 2016 5:02 pm

Early units might have the radio aerial hole in the passenger's guard.

Cheers

Bennie

Cliff R · Post by **Cliff R** » Mon Feb 29, 2016 5:29 pm

Thanks Bennie, good point

Silverbullet · Post by **Silverbullet** » Mon Feb 29, 2016 6:21 pm

Too true about the different markets = different holes; I got a drivers door for my wagon from a dismantlers (not self serve) the only one they had, was in silver, I figure must have been JDM or NZ import parts, no holes for the wing mirror!