The AUSubaru.com.au Forums

Hi all
Finally got some time after a couple of months to finish my EA82T wagon.
Just wondering if any one could help me out with a picture of the wires that are connected to the terminals of an EA82T ignition coil. The engine is ready to go just cant remember which wires go on which terminal. '85 Flapper type. Hopefully she'll run then.

Thanks, Timmo

blacks ur earth 2 wires...yellow positive has a grey cap if i remember right...if not reply and ill go look

wrx_nut

The black and white wire is your positive power in lead and the Yellow is the negative side, also your Tacho pick up. You will also have a grey shielded wire that goes to the negative side of the coil too.

maybee i was wrong :P havent had to look at mine since i did it
my bad

haha yeah you were suby wan was right but thanks for the reply anyway. SHES A GOER! yeeehaahh it feels good. thanks especially suby wan

No worries i know your elation i can still remember my sense of satisfaction when i finished my first EA82T conversion.