Page 1 of 1
Liberty/Impreza crossmember size
Posted: Fri Oct 23, 2009 3:48 pm
by niterida
Can anyone give me the measurements of the width a Liberty or Impreza front crossmember, from bolt hole to bolt hole ?
Posted: Fri Oct 23, 2009 4:20 pm
by AndrewT
I can when I next drop into my workshop, maybe tonight, but maybe tomorrow instead.
Interested in what your plans are to make you pose the question?
Posted: Fri Oct 23, 2009 4:22 pm
by niterida
Sorry can't say.
Plus if I did I would be shot down in flames........................
Posted: Fri Oct 23, 2009 4:27 pm
by AndrewT
haha ok PM it to me then...it's probably not as horrific as what I've already done to my wagon...
Posted: Fri Oct 23, 2009 5:27 pm
by niterida
OK got the measurement from rslibertyclub - 860mm
Posted: Fri Oct 23, 2009 9:08 pm
by AlpineRaven
arent both the same?
Cheers
AP
Posted: Fri Oct 23, 2009 9:48 pm
by niterida
AlpineRaven wrote:arent both the same?
Cheers
AP
Yes - thats why I asked for either one to be measured
Posted: Fri Oct 23, 2009 9:50 pm
by AlpineRaven
niterida wrote:Yes - thats why I asked for either one to be measured
if both are the same...
Wouldnt the engine mount points the same?
Posted: Mon Oct 26, 2009 3:18 pm
by wrxer
838mm and 860mm. 838 is rear holes and 860 is fronts. this is measured off wrx xmember laying under my bench
Posted: Mon Oct 26, 2009 4:27 pm
by AndrewT
AlpineRaven wrote:if both are the same...
Wouldnt the engine mount points the same?
lol, you miss-understand. He just wants the measurement of the crossmember, the reason seems to be a secret, but I suspect he wants to mount the crossmember in something other than a Liberty or Impreza.