The AUSubaru.com.au Forums

Hey guys,
Got a 2000 EJ25 SOHC Auto Outback in at work with the Airbag light. Non of the other guys know Subaru's...

Trying to clear the code/light... anyone know how to do it? We have a advanced Hanatech Scan tool but am unable to with that. After researching I have found that earthing the OBD II pin 1 and 2 will clear the codes but there are no wires connected to pin 1 and 2 on the port Mayber that is for the US models.

I have tried replacing the Airbaag Module and checked most of the connections.

Cheers,
Taza

2000 model is inbetween OBDII and the old plugging of the connectors together under the drivers footwell. (my liberty has both)

try disconnecting the battery for afew minutes. (of course if theres a problem, the light will continue to illuminate)

alex

I have tried the connectors under the dash, they only control the ECU and those codes. The Airbag module is completely seperate, I'm thinking there are more connectors somewhere that you connect to clear/check the A/B codes but I'm not sure where...

If I could check the codes for it, via making the Airbag light flash then I would be able to find where the problem is exactly. If there is even a problem..

just found this.

http://www.scoobymods.com/showthread.ph ... 13849.html

i know its for an 04 WRX but the same thing will probably apply

That vid was wrong Alex, there is no plug like that.

Gannon I don't see any connector or loose terminal like that. Does your Outback have it, I have even removed the fuse box from the OB.

Edit: Nevermind

Found it along side the ECU test connectors sorta above my right shin, just below the TCU

I see those two white plugs. I have tried both of them and earthing them out with no success.

Subaru Select Monitor.. take to Subaru