Page 1 of 1
97 WRX cam/crank/knock wiring
Posted: Mon Feb 20, 2006 7:41 pm
by Outback bloke
Does any one have or know where I could find a schematic layout for the 97 wrx cam, crank and knock sensor. It is the plug at the back of the engine that I am needing to know what goes where.
Posted: Mon Feb 20, 2006 8:35 pm
by Pete
I have soft copies of the 02 WRX manual if that is of any help ?
Posted: Mon Feb 20, 2006 8:43 pm
by Outback bloke
Thanks for the offer but they are different. I have 95, 99, 02, and 04 diagrams and none of them match the 97.
Posted: Mon Feb 20, 2006 10:23 pm
by Pete
Can you get enough access in the sensor conn's to fish around with an audible multimeter to figure out the pin outs or do you need something specific like a conn Part number ?
Posted: Tue Feb 21, 2006 10:09 am
by PeeJay
I have got some that claim to be 97 Legacy, not sure if they will help or not, but I sent them anyway.
Posted: Tue Feb 21, 2006 11:27 am
by vincentvega
surely Al has what your after?
Posted: Tue Feb 21, 2006 8:00 pm
by Craigus
I'm sure that I'm missing the point of the question, but can't you actually physically see which wires go to which sensors ? What specifically do you need to know?
Posted: Tue Feb 21, 2006 8:51 pm
by jzk25
Is this for that harness you got from Tim?
Posted: Sat Feb 25, 2006 3:54 pm
by Jeff
Brett i have several 97/98 wrx manifolds with harnesses attached your welcolm to come and work out what you need
Jeff
Posted: Sat Feb 25, 2006 4:54 pm
by Outback bloke
All done now. Car starts so it must be wired in properly.