Page 1 of 1
4x4 or 2x4 flywheel?
Posted: Fri Mar 28, 2008 4:54 pm
by esray71
Does anyone know the difference between the flywheel of the 4 wheel drive and 2 wheel drive?? I have a 94 L series wagon EA82 Carb 4x4. Had a look at the wreckers and they didn't have them marked well enough and they could not decide which one was the 4x4 flywheel. The 2 they had where different, one had a bevelled edge (45degree) and the other was a square edge (90degree). Any help would be greatly appreciated, thanks!
Posted: Tue Apr 01, 2008 4:16 pm
by El_Freddo
The two wheel drive flywheel uses a smaller clutch setup:
The 4wd clutch will bolt up near the outter edge of the flywheel
The 2wd clutch will be an inch or so in from the otter edge of the flywheel where it bolts up.
Hope this helps.
Cheers
Bennie
Posted: Tue Apr 01, 2008 7:58 pm
by Suby Wan Kenobi
The bevelled flywheel is from an EA81 and the spare edge from the EA82 if you have a FWD clutch they run a smaller diameter clutch plate with a thicker wall on the flywheel. They also have a smaller spline (same as MY series) on the clutch plate. EA and EJ cltuch plates are the same spline.
Posted: Tue Apr 01, 2008 9:51 pm
by Matatak
Suby Wan Kenobi wrote:EA and EJ cltuch plates are the same spline.
Lseries and EJ..but not EA81 boxes
Posted: Wed Apr 02, 2008 8:51 pm
by esray71
Great thanks guys!