Page 1 of 1
Brumby rear torsion bars
Posted: Sat Aug 20, 2011 8:38 pm
by niterida
How do remove the torsion bars out of the torsion tube in the rear end of a Brumby ? Do they just come out with a bit of gentle persuasion ?
I have everything off the tube except the adjuster in the middle as I can't see any way of getting to this.
Posted: Sat Aug 20, 2011 8:43 pm
by D3V1L
gentle persuasion might be an understatement sometimes
davo
Posted: Sat Aug 20, 2011 8:57 pm
by niterida
D3V1L wrote:gentle persuasion might be an understatement sometimes
davo
Yeah thought so - didn't want to waste my energy and find out there is a bolt somehwere holding it on - done that before and its not fun.
Guess I will have to go buy a new sledge hammer handle - broke it today getting the hubs off the cv shafts
Posted: Sat Aug 20, 2011 9:30 pm
by D3V1L
big hammer, and cold chisel and wedges are your friend
davo