legacy lsd diff question

Get the most out of your Engine / Gearbox with these handy hints ...
Post Reply
User avatar
00
Junior Member
Posts: 12
Joined: Thu Oct 06, 2005 10:00 am
Location: virgina

legacy lsd diff question

Post by 00 » Fri Oct 21, 2005 4:10 am

I have a 1995 legacy 2nd generation, I have raised it with outback struts and am running 28 inch all terrains, I have ordered some skid plates and am now looking to improve the traction some more. Can anybody tell me what ratio my rear diff is and if there are any subaru lsd's that can bolt in, quaiffe makes and lsd but i'm not sure if its for just the impreza, plus its like 1500 dollars, so I am hoping there is something out there that costs less. Any information would be greatly appreciated.

thanks in advance

User avatar
tim_81coupe
General Member
Posts: 1693
Joined: Tue Oct 04, 2005 10:00 am
Location: Perth

Post by tim_81coupe » Fri Oct 21, 2005 9:24 am

Your diff could be one of several ratios.

It's written on the sticker on the rear cover of the diff.

User avatar
jzk25
Junior Member
Posts: 213
Joined: Sun Oct 09, 2005 10:00 am
Location: Bonnydoonan

Post by jzk25 » Fri Oct 21, 2005 12:54 pm

Stickers are only on gen 1's, the later diffs have a two letter paint code on them to id the ratio.

00, what country are you in, what engine is fitted, what trans is fitted?
There are a lot of ratio and diff types(there is a small and large diff in the gen 2's).

Once you figure the ratio you can work out whether ther is a factory LSD to suit, if there isn't you can fit the LS centre into an alternate ratio.

User avatar
00
Junior Member
Posts: 12
Joined: Thu Oct 06, 2005 10:00 am
Location: virgina

Post by 00 » Sat Oct 22, 2005 5:37 am

I live in the usa, it has the 2.2 engine and an automatic transmission

User avatar
Outback bloke
Senior Member
Posts: 2103
Joined: Fri Sep 30, 2005 10:00 am
Location: Morayfield - Queensland
Contact:

Post by Outback bloke » Sat Oct 22, 2005 5:48 am

If the car was in Australia I would say fro sure that it had a 4.111 diff. I would guess that you would have the same there but not 100% sure. Yes you can get a factory 4.111 ratio LSD.

User avatar
jzk25
Junior Member
Posts: 213
Joined: Sun Oct 09, 2005 10:00 am
Location: Bonnydoonan

Post by jzk25 » Sat Oct 22, 2005 7:30 am

Agreed, it should be 4.11 but a lot of gen 2 auto's had R140 diffs. You can ID this by the filler and drain bungs. R140 has two 17mm hex head bungs like the engine sump plug, R160 has two 1/2 inch square drive tapered bungs.

Either way an LSD will be available for it but you will need the rear shafts to match.

User avatar
AlpineRaven
Senior Member
Posts: 3682
Joined: Wed Oct 19, 2005 10:00 am
Location: Melbourne, Victoria, Australia.

Post by AlpineRaven » Sat Nov 12, 2005 10:33 am

I know that my Liberty has 3.7:1 rear diff. its AWD 5MT Single range.
Cheers
AP

Post Reply

Return to “Engine, Gearbox and Diff”