The AUSubaru.com.au Forums

Brumby pulls to left on acceleration, left cv boot needs replacing but only went recently, left wheel slight wobble when pulling on it. read a post a while ago where someone knew the problem but cant find it now. is it steering link, CV, wheel bearing or something else?

check your hub nut they have a habit of comimg loose check your rack as well......

What way are u pulling the wheel when it wobbles?

Get the wheel off the ground... grip either side and it wobbles then it is likely to be rack.... if it does it top to bottom at all it is likely to be wheel bearings.

But as suggested... check the hub nuts.

Dave

looks to be the rack, no movement pulling top and bottom, only movement in the wheel side to side and can see the steering arm with movement in and out. what do I have to do to fix it, is it a bit job?

youl need to put a nother rack in it they are pretty easy to fit up....

I'm just trying to find the manual, but I cant remember where I put the darn thing. I've only just moved so It could be anywhere.
do i get a new rack from dealer,repco, or wreckers ?

thanks for your help guys

you can get a price for a new one but i think you will find they are expensive hey id just get a second one..put a post up in the wanted section you might get one cheap hey..

cheers, will do that tmrw, Im going to investigate it a bit more and take it apart.

check that its not the tie rod end on the steering rack...save u money instead of replacing the whole rack, that was what was causing the play in my steering

edit: i will reword it...the ball joint on the steering rack to tie rod...excuse my primitave explinations first time round....

dave

I'll check it out, fingers crossed that its something more simple and cheaper.

p.s Im still looking for my subie mech manual, getting so frustrated, where the hell did I put it? arrh!

all good, replaced left rack end and had a steering alignment done. the pulling has gone and steering is toit again! just one Q? can ya f@$% the front drive to wheels when you pull a drive shaft out of the gear box to change CV boots. Gear box also seems to have excessive wind noise in reverse when foot on clutch and car rolling? didnt seem to have it before. oil problem maybe?

$40 for new rack end from repco by the way

PM sent Soobeit