Changing brake pads on Vortex
Posted: Fri Jan 16, 2015 7:39 am
Hey guys, does anyone one know what the special tool is called that you use to wind the piston back in to the calliper?
Canny
Canny
The AUSubaru.com.au Forums
One of Australia's original and top performing Subaru sites. Come and have a look and find out why so many people enjoy this site.***ONLINE SINCE SEPTEMBER 2018*** site address: www.ausubaru.com.au
https://ausubaru.com.au/
Changing brake pads on Vortex
Page 1 of 1
Posted: Fri Jan 16, 2015 8:29 am
I can't remember the name but Repco sell a multifit one fror around $15, I bought one last year.
Posted: Fri Jan 16, 2015 8:33 am
This is it.
Posted: Fri Jan 16, 2015 1:13 pm
and there is a different one to Willys depicted tool.
Picture a socket say a 32mm one, half inch drive, and has had the 32mm open end cut down to leave two castellation like bits that lock in and allow you to rotate the piston so you can wind it back. Turn in a clockwise direction.
Picture a socket say a 32mm one, half inch drive, and has had the 32mm open end cut down to leave two castellation like bits that lock in and allow you to rotate the piston so you can wind it back. Turn in a clockwise direction.
Posted: Fri Jan 23, 2015 10:10 pm
I use a pair of pliers to do mine.
Have since got the same as Willy above, but am yet to actually use it...
Cheers
Bennie.
Have since got the same as Willy above, but am yet to actually use it...
Cheers
Bennie.
Posted: Tue May 05, 2015 10:22 pm
I've been using a set of bullnose pliers since 1992 and never worried about buying a "special" tool as the plier method works perfectlyEl_Freddo wrote:I use a pair of pliers to do mine.
