Page 1 of 3
EOI Project Brumby Components
Posted: Sun Apr 04, 2010 7:08 pm
by Corax
Hey Suba-Dudes,
Time to unload a shirtload of stuff. Will put up photos in the for sale section if anybody shows interest. This was going to be a project build but due to me getting another 'project car' this one is just not going to happen. Items include...
1. 1985 Targa Brumby with 2" lift kit, 14" rims, central locking and a slightly customised interior. Not the best out there but far from the worst.
2. 2002 EJ25 SOHC motor with full wiring harness and ECU. Done 63K
3. Injen cold air intake kit for the above moter. Never been installed.
4. Headers/Extractors for the EJ25.
5. Manual Gearbox from a late 90s RS turbo.
Plus boxes of other stuff mainly from a 2002 RS impreza. Other stuff as well but cant think of it at the mo.
Please note as well if you pm me it might be a while before I get back to you as I am not always in front of a pc.
Cheers,
Corax.
Posted: Sun Apr 04, 2010 7:29 pm
by TOONGA
Ive seen the brumby thats up for sale and I can say grab it quick (wish I had the money I would for sure)
TOONGA
Photos
Posted: Mon Apr 05, 2010 4:21 pm
by Corax
Hey Suba-Dudes,
Trying to upload some photos... you'll find them somewhere on this site!
Cheers,
Corax
Posted: Tue Apr 06, 2010 12:49 am
by Corax
more photos
Posted: Tue Apr 06, 2010 12:43 pm
by chriSTIan
Are you selling in one package or splitting up?
Is the brumby running?licenced?
Price?
Thanx
Chris
Posted: Tue Apr 06, 2010 10:39 pm
by Corax
Ok not many photo's won't let me upload more than one at a time. To frustrating.
Prices
Brumby 3900 ono.
Motor+ecu 1000 ono
Injen kit 200 ono
Extractors 150 ono
Gearbox 400 ono
Also got a converted radiator, hydralic clutches and lots of other stuff.
Chris - Yeah the brumby is licenced and runs and yeah would like to unload it all to the same person if i could. Would like to see this moter dropped in this car:) Would seriously discount the above total of the above prices if someone was going to carry on with the project. Would also like to see this car go to a good home.
Cheers,
Corax.
Posted: Fri Apr 09, 2010 5:20 pm
by TOONGA
well I went to see Corax today and grabbed the headers and converted radiator so they are gone but he still has all of this to sell
late 90's gearbox (he may even throw in the cement ring)
assorted dash components and air pipes
heater /aircon box and filter
3 of these rims and the emergency spare
Injen air kit complete (the kit is new as well) with bonus air sensor
brumby radiator (used)
Ej25 complete harness, plus computer and rear harness and spare front harness
more to come
TOONGA
Posted: Fri Apr 09, 2010 5:22 pm
by TOONGA
power steering? and more air bits
dash stuff
steering knuckle
bits (boxes not included)
Hydraulic clutch kit peddle master and slave x2
More to come
TOONGA
Posted: Fri Apr 09, 2010 5:22 pm
by TOONGA
centre consoles
EJ25
the brumby
last but not least some EJ flywheels (one seems to be dual plate)
TOONGA
TOONGA
Posted: Fri Apr 09, 2010 10:18 pm
by RSR 555
TOONGA wrote:brumby radiator (used)
I'd like this
TOONGA wrote:Hydraulic clutch kit peddle master and slave x2
And this too please
Posted: Sat Apr 10, 2010 8:31 pm
by chriSTIan
What car did all this gear come from?What year?
Posted: Sat Apr 10, 2010 9:12 pm
by TOONGA
the Ej25 is from a 2001 (can't remember what car corax said it was) so most of the interior is 2001 the gearbox however is from a late 90's rx
TOONGA
Posted: Sun Apr 11, 2010 12:44 am
by Corax
Motor, harness, interior plastics and the majority of the stuff in the plastic tubs comes from a 2001 RS Imperza. The bloke I bought it all off said that the car that they were taken from had done only 63000km's. Bit of a weird story really, his mate bought a 2001 2.5 impreza and decided it wasn't fast enough so he had it converted into a WRX ie 2.5 turbo. This stuff is everything subaru had to rip out to put in the new motor. Would have been cheaper to sell the original car and go off and buy a WRX in my opinion.
The rest of the stuff is just things I have found trawling the net that I was going to use in the conversion of the targa brumby. Personally I think this car would have rocked with his motor in it.
Cheers,
Corax.
Posted: Fri Apr 30, 2010 7:03 pm
by chriSTIan
Hi
Have you sold the engine?
Is it in Bunbury?
Posted: Mon May 03, 2010 11:02 am
by Corax
Hi ChriSTIan,
Yeah still got it, plenty of interest but no-one seems to be able to come up with the money. Yeah its in Buno.
Cheers,
Corax.
Posted: Wed Jun 23, 2010 5:58 pm
by TOONGA
radiators are gone, box of slave and master cylinders are gone, wheels are gone (safety tyre is still there) consoles are gone
everything else is still for sale
TOONGA
Posted: Sat Jun 26, 2010 4:12 pm
by Corax
Gearbox is gone. Come on guys there must be someone out there who wants to drop an EJ25 into their Brumby:)
Posted: Wed Jun 30, 2010 11:37 am
by Chrus
Hello Corax - is this brumby still up for grabs? Targa version is wicked imo!
Posted: Wed Jun 30, 2010 8:34 pm
by Corax
Hi Chrus,
Yeah mate still got it, and yeah the targa version rocks! Plus on this car they dont leak either.If you want to come and have a look sometime just pm me and we can organise a time/place. Note that I live in Bunbury. Also if you want another independent opinion about the car you can talk to Toonga as he has seen it a few times.
Cheers,
Corax.
Posted: Wed Jun 30, 2010 10:51 pm
by Chrus
Corax wrote:Hi Chrus,
Yeah mate still got it, and yeah the targa version rocks! Plus on this car they dont leak either.If you want to come and have a look sometime just pm me and we can organise a time/place. Note that I live in Bunbury. Also if you want another independent opinion about the car you can talk to Toonga as he has seen it a few times.
Cheers,
Corax.
PM sent boss