few bits no longer needed

Chris_Rogers · Post by **Chris_Rogers** » Fri May 21, 2010 10:33 pm

legacy engine - which one EJ20R?

seagull · Post by **seagull** » Sat May 22, 2010 9:31 am

single turbo legacy closed deck

Chris_Rogers · Post by **Chris_Rogers** » Sat May 22, 2010 10:08 am

ok thats not the one I was after. (think what you have is a ej20g.) ta!

seagull · Post by **seagull** » Sat May 22, 2010 10:27 am

EJ20R = 1993-1999 Legacy chassis code BD/BG5 JDM RS-B and GT-B's (205 kW (279 PS; 275 bhp) Manual)

why would you want this ?

Chris_Rogers · Post by **Chris_Rogers** » Sat May 22, 2010 10:34 am

closed deck,forgies and to me a better block. heads were bucket and shim I thought. am I wrong?

Chris_Rogers · Post by **Chris_Rogers** » Sat May 22, 2010 10:35 am

mine is open deck and cast gear. looking for a second one for when it dies.

seagull · Post by **seagull** » Sat May 22, 2010 10:37 am

are your injectors yellow ?

Chris_Rogers · Post by **Chris_Rogers** » Sat May 22, 2010 10:41 am

existing ones are brown I believe.

seagull · Post by **seagull** » Sat May 22, 2010 10:45 am

Then the TT motor you have is no better than a 1996 wrx motor with a TD04 single turbo , possably the worst of the lot some say.

GTB have yellow injectors , heads ( cams ) are close to the V3STI, pistions are not the full forge units.

I have this motor in my liberty, single turbo goodness:)

Chris_Rogers · Post by **Chris_Rogers** » Sat May 22, 2010 11:03 am

ah ok. you have done what I wish to do. I have lined up the later turbos and I can find the later engines cheapish but getting them here kills the idea.

seagull · Post by **seagull** » Sat May 22, 2010 2:05 pm

TT , is not the way to go. Single all the way

Chris_Rogers · Post by **Chris_Rogers** » Sat May 22, 2010 8:11 pm

too much hassle for me to go the single route. just looking for a better block to build up to standard trim. can't really raise the boost on this thing without getting into the ECU and thats not going to happen.

seagull · Post by **seagull** » Sun May 23, 2010 1:33 am

I had Al at am auto do my loom, TT to single V3STI with speed cut unit fitted
he is local to you