Page 1 of 1
MY clock makes way for....
Posted: Sun Sep 30, 2007 2:49 am
by steptoe
a 2" electric oil pressure gauge. Fiddling with a nagging idea this arvo, I removed the clock from a spare gauge unit, drilled a coupla holes thru circuit board where it didn't matter and bingo, an oil presure gauge will soon be sitting neatly where the clock was in my Brumby
Posted: Sun Sep 30, 2007 3:39 pm
by Subafury
noice. on the subject, what should an L series oil pressure be reading? at cruising, start up, underload etc, mine sems to vary all over the place.
Posted: Mon Oct 01, 2007 9:13 pm
by steptoe
about the middle of the dial as far as I reckon.
This is gonna work out nicely as I can power and ground the gauge off the back of the circuit board and use a spare pin to fit a lead into the connector at the back - reducing the wiring to a minimum