Page 1 of 1
Pedal covers for brumby?
Posted: Sun Jul 31, 2011 4:48 pm
by Backyard_Brumby
When I bought the brumby it had some awful aftermarket pedal covers that made me cringe, I then replaced them with ones that were only slightly better. The problem with both sets were that because the pedals are so close together you couldn't drive with shoes on or there was a fairly good chance you would end up hitting both the accelerator and brake at the same time ....not a good look doing front wheel burnouts in a farm ute down at woolies haha
So my question is are there still oem rubber covers available...if so any thoughts were to get them ?
cheers again
Posted: Sun Jul 31, 2011 6:26 pm
by dfoyl
Should still be available from Subaru, check with user frog or drop into your dealer.
They do perish (harden) with age, I replaced mine with an early MY wrecker and they were very difficult to slip over the metal pedal.
Posted: Sun Jul 31, 2011 6:37 pm
by mud_king91
Try repco or bursons
Posted: Sun Jul 31, 2011 6:44 pm
by littlewhiteute
Posted: Sun Jul 31, 2011 8:21 pm
by Backyard_Brumby
Cheers for the replies guys.
My next point of call was to just pm Frog haha
I do remember from my days at supercheap It said that I could order rubber pads in pretty cheap but they were the same code for the liberty and a couple of others so I wasn't sure about them.
I do like them gary, I would prefer if they were a little cheaper but they would be good.
Posted: Mon Aug 01, 2011 12:22 am
by sven '2'
Very much still available as OME part! Bought 4 a few months back
Have not changed from the Ugly -> MY/MV -> L-Series -> Liberty -> Forester (01) -> Forester (11)
$6 or something like that.