The AUSubaru.com.au Forums

Hi guys,

I know this has been asked before on how to make an extension for the 2" lift steering however I have tried again and again with no success. I found out the extra knuckle I was using was for the power steering mod. I don't want to bodge something up so my big question does anyone have one made up that they would be willing to sell or trade?


Cheers again

A photo essay





with the above linkage setup use the two longer bits for a power steering set up(with or without the rubber vibration stopper) and remember to bolt it all together nice and tight. (no need for the extension block)

for a non power steering setup use the short end and the long end with the rubber vibration stopper, or use the standard liberty or l series knuckle shown in the picture below (top knuckle) the bottom knuckle is from an outback



images stolen from these threads

showthread.php?t=18281&highlight=steering+extension
showthread.php?t=19731

GOOD LUCK

TOONGA

Thanks for that TOONGA, I am sure it has been said many a time but for some reason I couldn't quite gather what I needed. so it looks fairly simple I will just need to source a liberty steering knuckle.

not a problem Im pretty sure the standard liberty linkage/knuckle will fit as I think thats what RSR555 used on his brumby either that or the L series linkage

TOONGA