Page 1 of 1
Brumby seat question
Posted: Tue Nov 23, 2010 1:00 am
by phantomD
Hi all,
My Brumby seat is poking me in the back and causing me back pain - how much would it cost to get both seats refurbished in Brisbane? Any places recommended?
Can somebody please tell me which model/year Liberty the seats below came from:
Are modifications required to fit them to a Brumby?
Cheers,
D
Posted: Tue Nov 23, 2010 5:57 am
by Captain Obvious
they are the same as my seats, gen 1 ser 1 liberty!!
Posted: Tue Nov 23, 2010 3:40 pm
by RSR 555
Yep.. Gen 1 Series 1 GX Liberty seats.. I prefer the RS Turbo seats in there, as they have the slightly rap around sides
Posted: Wed Nov 24, 2010 3:15 am
by phantomD
Much modding required to put them in?
Seat option
Posted: Wed Nov 24, 2010 3:40 am
by 1111giles
Check out Foz seat too they fit well (with mods to the fixings) get the correct colour and they look factory ! Dinky arm rests are good too
See image of my set up
Posted: Wed Nov 24, 2010 9:31 am
by TOONGA
D this will help you out on the "can I fit these in my brumby" question
1998 Gen2 seats into 1984 MY wagon
not gen1 series 1 but I hope this helps
TOONGA
Posted: Wed Nov 24, 2010 1:12 pm
by tex
the rails (the bits that bolt between the seats and the floor! will normally be the bits that have been modified so another set of liberty seats should bolt up if you remove the seats and bolt the old rails onto the new seats!