Page 1 of 1
Fitting a L series bullbar to a Brumby
Posted: Sat Jul 03, 2010 12:27 pm
by Green_eyed_liberty
will a Bullbar for an L Series fit a brumby?
i've been told they dont fit, how far dont they fit?
could it be easy modified to fit? or will i need to sell it lol
cheers guys
Posted: Sat Jul 03, 2010 12:40 pm
by Subafury
no. bugger it off it wont fit.different width chassis rails.
Posted: Sat Jul 03, 2010 10:59 pm
by El_Freddo
^ what subafury said + the L series bullbar has the captive nuts on it where as the MY or brumby's "chassis rail" will have the captive nuts in it. The bullbars are a physically different in width as well, not by much but enough not to look the part...
Cheers
Bennie
Posted: Sun Jul 04, 2010 5:53 pm
by stamp_licker
I've made one that was fitted on a brumby fit my L .It's just a couple of bolt on brackets easy to fab. A reversal shouldn't be hard , L to brumby should be doable .
Posted: Sun Jul 04, 2010 8:49 pm
by Wagonman
I fitted a brumby bullbar to my L. Had to modify (hack the crap out of) it because it was too narrow so i would think an L series one IF you could get it to fit would look very out of place. good luck if you try though mate
Posted: Sun Jul 04, 2010 10:55 pm
by red_rocket
ill take the L bullbar if you dont use it...shipping will kill though