Page 1 of 1
torque setting for knock sensor ?
Posted: Tue Feb 10, 2009 8:22 pm
by steptoe
According to WSM the knock sensor s to be tightened to specs
I cannot find
Anyone know ?
EA82
ta,
Posted: Tue Feb 10, 2009 9:06 pm
by Suby Wan Kenobi
25-35Nm but as they are tapered i have usually done them up so they are just tight, which would be in the ball park of the torque spec anyway
Posted: Wed Feb 11, 2009 8:57 am
by steptoe
Thanks Suby Wan Kenobi. I will shove that in the manuals somewhere I CAN find it.
BTW, did you get this figure from the manuals, if so where ??
Jonno
Posted: Thu Feb 12, 2009 5:32 pm
by Suby Wan Kenobi
From the FSM
Posted: Thu Feb 12, 2009 6:10 pm
by stinky
I think it's 18 lb/ft in imperial.
Posted: Fri Feb 13, 2009 8:28 am
by steptoe
Thanks guys , converts to 18 - 25 ft lbs
Posted: Sat Feb 14, 2009 10:34 am
by tex
How much did your Knock sensor cost you my poor wagon needs one.
Posted: Sat Feb 14, 2009 10:37 am
by vincentvega
EJ22 = $140ish
Posted: Sun Feb 15, 2009 9:03 am
by steptoe
tex, wasn't fitting newie, just swapping between motors