Brumby weather seals

Backyard_Brumby · Post by **Backyard_Brumby** » Tue Mar 05, 2013 12:11 pm

Hi Guys,

I have asked this question before but am still in need of some help. I am after the weather seals for the doors on my 89 brumby.

The hard strip on either side of the window that prevents water from getting inbetween the door. The soft strips around both the door and the cab.

I have asked the always helpful frog as well as all the subaru specialists I know of in South East Queensland but to no avail. So my big question does anyone know of a business that could do custom seals or has come up with a solution?

Failing that does anyone have a good set of used ones?

Thanks so much for the help, at the moment the whole rebuild is hanging on getting these seals.

niterida · Post by **niterida** » Tue Mar 05, 2013 12:26 pm

I have a spare set of the door seals - will check when I get home to make sure they are all OK.
I may also have the window seals too but don't think they are in very good condition.

I've heard they are like rocking horse poo so I hope you have deep pockets

T.Farm.Brumby · Post by **T.Farm.Brumby** » Wed Mar 06, 2013 12:05 pm

Might have a the whole shebang for a drivers side door, off an '89 Brumby. Wrapped around a tree so there's no passenger's side though :/

Oh, and I'm in SE Queensland, so delivery etc shouldn't be an issue

Backyard_Brumby · Post by **Backyard_Brumby** » Wed Mar 06, 2013 12:08 pm

Sorry to hear about the poor brumby mate, send me a pm as I am definitely interested (half is better than none

) Depending on condition I might be interested in taking the door off you too, if you were interested.

T.Farm.Brumby · Post by **T.Farm.Brumby** » Wed Mar 06, 2013 12:14 pm

Backyard_Brumby wrote:Sorry to hear about the poor brumby mate, send me a pm as I am definitely interested (half is better than none ) Depending on condition I might be interested in taking the door off you too, if you were interested.

Sent

Also, wasn't mine, was a friend's and happened YEARS ago, only had 72000 on it

been scavenging parts for a while now haha

RSR 555 · Post by **RSR 555** » Thu Mar 14, 2013 3:16 pm

Would they be available in the US?

Backyard_Brumby · Post by **Backyard_Brumby** » Thu Mar 14, 2013 3:39 pm

Unfortunately not that I have been able to find. It was the first place I looked. Only found a place that were happy to mould up and make new sets however they would need a good factory set to start.

Managed to get a set thanks to a member on here so hopefully that will get us through

Surprised no one else has had big issues though.

Silverbullet · Post by **Silverbullet** » Thu Mar 14, 2013 5:30 pm

Hey any rough estimates on what it costs for them to mould up and make new ones? I was hoping for all new seals for my wagon but they don't exist. I'm looking at getting new ones made but no idea on costs yet.