The AUSubaru.com.au Forums

Sorry for reviving this thread... Does anyone know of any potential trouble points causing this problem? I have the exact same problem - fuse for taillight, license and instrument illumination keeps blowing. Tail and license light and wiring in the aft cabin has been checked.. which leaves me with t...

Hmmm thanks for the replies. I doubt its the CV as i put in reconed ones not long ago. Ill check today anyway. Could it be the transfer case or front diff?

Also, There is no noise in 4wd mode. If it was CV, should the noise continue in 4wd mode? Thanks

Hi guys, thought i'd post this up for some advice. I have a 92 L wagon and it was fine until I stopped at a set of traffic lights a few hours ago. When the lights turned green and i let off the clutch with some gas as usual, I couldnt get any bite on the clutch at all. The gearbox gives a fast rattl...

prices did not go up from $1.57/L after cheap wednesdays here at epping again... Seems like servos here sell off their last stock "cheap" before another major hike. Im expecting $1.75/L this week due to the $139/barrel hike.

Hey guys, Just out of curiousity.. I was wondering if anyone else has noticed that petrol prices havent been following their regular price cycle in the past week. As of yesterday, all servos around my area (Ryde) were still at their low $1.36/L since last tuesday. I just find it odd that prices are ...

oh yea there was no excess movement/wobble anywhere before I took the shafts out. I could move the shaft around the rubber supports for the centre bearing though, but it was cushioned, as in the rubber would push it back to center. is that normal?

Hey guys thanks for the tips, especially andrew for the coke can tip! Im looking at the entire shaft assmbly right now. How can I tell if and which uni joints are gone? How can I tell if the centre bearing's gone too? I've got a gregory's manual here that says that I cant actually take the uni joint...

Thanks for the replies guys! Really appreciate it. I'll attempt to get to the centre bearing and uni joints later today. I have to get my rego renewed in 2 weeks. I wonder if its gonna affect the inspection...

Hi guys, thought I'd post this up to see if anyone else had the same problem with their L-series wagon. Pardon my ignorance in this matter. I'm not too mechanical-minded but I've tried to pinpoint the source of the problem. I get a wobbling noise/vibration from under the car at about 60km/h and it g...

thnx for the help guys. i managed to get it done by detaching the control arm from the crossmember. The problem was getting it in line to rettach it. But its been solved now by getting a huge rope loop aroudn the whole rig and twisting it tight haha.

Hey thanks for the tip. Im trying to replace both L n R drive shafts n joints. i decided to follow gregory's manual and detach the control arm from the crossmember completely. i changed the drive shafts but now i have another problem.. i cant get the control arm back into the crossmember. the nut ho...

oh and ive tried WD40 lubricant already... still doesnt budge... arhghh

Hi guys Im a technical newbie here in need of some help. Im trying to change the front cv shafts on my 92' L-series wagon and ive run into a lil problem. I cant seem to get the control arm from the crossmember loose and off the wheel hub assembly. Ive tried using a dolly and hammer (and sledge hamme...