The AUSubaru.com.au Forums

err, fuel pressure regulator ? If the diafragem gets a hole in it the vacuum side starts to supply unmetered/unatomised fuel into the inlet manifold ?? Simple test if fpr is easy access - just disconnect vac hose while running and see if fuel piddles out...... check, 2 different ones tried... I am ...

Tried a known good igniter? Also test the pulses to the injectors to make sure they're firing as they should be. When was the fuel filter last replaced? Is the knock sensor in good condition? Cheers Bennie the igniter that was on there was running an ej20 fine, but we swapped to the spares igniter ...

if i connect the DMM to the check engine pin while the connectors are unplugged and ignition to 'on' i get 12v, as i should. if i then connect the black plugs the DMM moves between 3-4v and 12v as i think it should when it is giving error codes (of course, the multimeter doesnt refresh fast enough t...

ej22 in l series when i pull one lead off the engine. It stops dead how ever yesterday it was fine and would still just run on 2 cylenders with 2 leads pulles off cant work out what has changed

if i unplug the o2 sensor it runns exactly the same is that normal

just tried swapping over a couple of o2 sensors and still the same i havent done an upper cylinder clean on it before how do i do that

i have an l series with ej22 conversion have 4 brand new leads and am getting a good spark at all plugs have swaped around most of the sensors with spare ones i have and no change have cheacked compression and all around 175psi so all good and have also done a leak down test and all good when i remo...

does any one know if a faultey egr valve could cause a car to missfire under reves and drop cylenders in and out at idle cheers rowan

does anyone know a good place in perth to get a set of rear l series hubs re drilled to 4x100

hi dave trying to contact you and your mail box is full

cheers guys ill try this

does any one know how i can send a private message to SuBaRiNo i sent him a message and he replied but mow when i try to reply back it just says SuBaRiNo has exceeded their stored private messages quota and cannot accept further messages until they clear some space. does any one know how i can conta...

what is the best way to get in contact caus i posted on his wall but no reply after about a week

does any one know where the blue and white plug goes on the L/H side of the coil

cheers guys thanks for the help

Does Any one know who in W.A can strip an ej harness
to put into an ea series car Cheers Rowan:)

Does any one know where abouts i can find a pinout for a 1997 subaru impreza auto Cheers Rowan:)

cheers guys but can someone tell me the wedge ratio like is it 1in10 or whats the go
Cheers Rowan

I herd the angle on the crossmember mounts is slightly out when dropping an ej20 into an l series does anyone know anything about how to make the wedges you need to put between the crossmember and engine.
Cheers Rowan

Cheers i was thinking that exedy would be good but just wanted to check
Rowan